D
3
P
Extrusion Calculator
Get Pronterface Print Run
Get Repetier Host
3
2
1
Calibrating
!FIRST HEAT THE EXTRUDER!
Current extrusion multiplier or flowrate
1
Milimeter to mark.
2
Extrution activated in milimeter
3
Milimeter to mark after extrution
4
5
6
4
Actual extruded in milimeter
NEW EXTRUDER MULTIPLIER >>>
5
USE Comma , in numbers not period. eg. 97,9
STEP 1
STEP 2
STEP 3 IMPORTANT
You MUST heat the extruder before you push extrude!
From your Slicer interface extrude 50mm filament
Mark the Filament with a pen 100mm from
the inlet to the bowden or extruder.
In your Slicer software locate the extrution multiplier Enter the number into field 1
STEP 5
STEP 6
STEP 4
Save the settings with the new value on your slicer. You now have the correct extruded filament.
Field 5 is the correct value for the feed rate. enter this into your slicer software
Messure the mark you made from the bowden inlet or extruder.
Enter the value into field 4
Ver 1.1
Copyright 2017 D3P and weitling.info
Page 1 of 2